Is handwriting & drawing support planned?
Is handwriting & drawing support planned?
19.16.39
Same here
The stars and planets, yes, but there is a lot of very diffuse gas that does collide
Fluorescent lighting 100%. Warm dimming LEDs behind a nice shade, on the other hand, can stay (preferably dimmed).
My personal idea/hope is that there is some other dimension of spacetime over which the big bang had directionality, emitting matter and antimatter across different poles, and that’s why. That’d also mean there’s an anti-universe, which is why I like the idea.
In terms of the galaxies, I believe there’s enough of an observable difference that I think we would be able to detect antimatter clusters, or similar, based on emission lines but I’m not 100% on that. Huge annihilation events from colliding galaxies and clusters would have massive energy signatures unlike anything else but the frequency of this would determine how likely it would be to see the evidence.
Oops responded to the wrong comment
deleted by creator
That’s what we genuinely don’t know. Based on the standard model, it should be in equal parts.
Sounds like you were engaging in whataboutism and that was the problem
I’m with you on the punctuation. The k bit I think is about showing you are putting effort in to understand and care, so something slightly longer like “k… I understand” or some extra acknowledgement that shows you understand and have taken the time to take it in helps. Personally, I have a big thing about miscommunication, so knowing people have understood me and listened actively is huge to me. “K.” does not express much of anything other than “I saw there was a message”, so I’d want to push to check that I’ve actually been heard.
Hope that makes sense.
I moved from Splitwise to Splid. I wish I had a FOSS alternative too.
Ah sorry, I missed a bit in your post - it’s correction during typing only. Upping this setting could help but I suspect you want something else
Heliboard isn’t perfect but is an openboard fork that has spell check, is getting active development, and is on F-droid. There’s even a correction sensitivity setting. It’s the first time I’ve been able to move away from Swiftkey.
I’ve used a larger version for cold brew in the past and it worked well. It was a bit annoying to clean out but cold brew batches arent every morning so it was fine.
My preference is now an aeropress with a fabric filter. I use this above a metal filter with the Prismo attachment (metal to stop the fabric clogging the valve). The fabric circle is small enough to be easy to clean, freeze and thaw. I usually only rinse it (much easier with a small flat disk) before chucking it in the freezer but I use Cafitza to clean it every few months to remove any built up oils (just gotta give it a few soaks in boiling water afterwards to ensure its not holding on to the cleaning agent!).
Almost the same as my PC from 2014, which unfortunately is also my current PC. I had an asus mobo though.
Ah, thanks for the answer, I’d missed this on the GH page. Unfortunately, that’s not what I’m after as I know I will end up with a complete mess of unusable notes or not use it at all if there are any stages of choosing a note type.
Ideally, I want version controlled, editable, searchable, taggable paper I don’t have to file away, which I can also type on and use other digital tools with (e.g for things like diagrams, spreadsheets). I haven’t seen anything particularly close to what I’m after yet but I’m hopeful that it’ll come eventually.